Home
Giới thiệu
Tài khoản
Đăng nhập
Quên mật khẩu
Đổi mật khẩu
Đăng ký tạo tài khoản
Liệt kê
Công trình khoa học
Bài báo trong nước
Bài báo quốc tế
Sách và giáo trình
Thống kê
Công trình khoa học
Bài báo khoa học
Sách và giáo trình
Giáo sư
Phó giáo sư
Tiến sĩ
Thạc sĩ
Lĩnh vực nghiên cứu
Tìm kiếm
Cá nhân
Nội dung
Góp ý
Hiệu chỉnh lý lịch
Thông tin chung
English
Đề tài NC khoa học
Bài báo, báo cáo khoa học
Hướng dẫn Sau đại học
Sách và giáo trình
Các học phần và môn giảng dạy
Giải thưởng khoa học, Phát minh, sáng chế
Khen thưởng
Thông tin khác
Tài liệu tham khảo
Hiệu chỉnh
Số người truy cập: 109,887,085
Geometric influence of width ratio and contraction ratio on droplet dynamics in microchannel using a 3D numerical simulation
Tác giả hoặc Nhóm tác giả:
Le Hung Toan Do, Thanh Tung Nguyen, Van Thanh Hoang*, Minh Sang Tran
Nơi đăng:
Heat Transfer, Wiley;
S
ố:
2024;
Từ->đến trang
: 1-14;
Năm:
2024
Lĩnh vực:
Khoa học công nghệ;
Loại:
Bài báo khoa học;
Thể loại:
Quốc tế
TÓM TẮT
Microchannel geometry is an important factor in determining droplet dynamics in droplet-based microfluidic systems, much like fluid properties and flow conditions. In this context, two important geometric parameters—the contraction ratio (C
II
𝐶
II
) and the width ratio (C
I
𝐶
𝐼
)—that are limited to particular value ranges are taken into consideration for evaluation. These parameters interact with the capillary number (C
a
Ca
) and viscosity ratio (
𝜆
) to affect different aspects of droplet migration and manipulation, such as trap and squeeze regimes. A theoretical model is proposed, and a three-dimensional numerical simulation method is used in this work. This model predicts the change from trap to squeeze, which is caused by the interaction of the previously mentioned variables. Interestingly, an inverse correlation exists between the width ratio and the critical capillary number for this transition, which is determined as
≥
𝑓
(
𝜆
,
𝐶
II
)
/
𝐶
𝐼
. Furthermore, the investigation explores the droplet elongation and velocity ratio during their passage through the microchannel. By matching input parameters with microchannel geometry, this information may be useful for the design of microfluidic systems, which would facilitate the careful control and manipulation of droplets.
ABSTRACT
© Đại học Đà Nẵng
Địa chỉ: 41 Lê Duẩn Thành phố Đà Nẵng
Điện thoại: (84) 0236 3822 041 ; Email: dhdn@ac.udn.vn