Home
Giới thiệu
Tài khoản
Đăng nhập
Quên mật khẩu
Đổi mật khẩu
Đăng ký tạo tài khoản
Liệt kê
Công trình khoa học
Bài báo trong nước
Bài báo quốc tế
Sách và giáo trình
Thống kê
Công trình khoa học
Bài báo khoa học
Sách và giáo trình
Giáo sư
Phó giáo sư
Tiến sĩ
Thạc sĩ
Lĩnh vực nghiên cứu
Tìm kiếm
Cá nhân
Nội dung
Góp ý
Hiệu chỉnh lý lịch
Thông tin chung
English
Đề tài NC khoa học
Bài báo, báo cáo khoa học
Hướng dẫn Sau đại học
Sách và giáo trình
Các học phần và môn giảng dạy
Giải thưởng khoa học, Phát minh, sáng chế
Khen thưởng
Thông tin khác
Tài liệu tham khảo
Hiệu chỉnh
Số người truy cập: 107,318,269
Long Range Wireless Data Acquisition System for Rail Track Health Monitoring System using Arduino
Tác giả hoặc Nhóm tác giả:
VT NGO, Yujin Lim
Nơi đăng:
한국철도학회 학술발표대회논문집, Hàn Quốc;
S
ố:
한국철도학회 학술발표대회논문집, 2018;
Từ->đến trang
: 493-494;
Năm:
2018
Lĩnh vực:
Kỹ thuật;
Loại:
Bài báo khoa học;
Thể loại:
Quốc tế
TÓM TẮT
This paper describes a new pilot development of ARDUINO based health monitoring system to make a Long Range Wireless Data Acquisition System (LRW-DAQ). This device is used for monitoring the wheel load and the vibration of the slab when the rail car passed. Because the existing DAQ systems are usually expensive and complicated for setup and maintenance, they are not suitable to build an IoT system to monitor the railway slab track system. For this purpose, the prototype, which is made from Teensy-a USB-based microcontroller development system, is made to capture the data. Then the data will be stored in SD card. After that, it will be transferred to the coordinator via ZigBee/IEEE 802.15. 4 protocol. This system has been tested by comparing with another commercial DAQ system.
ABSTRACT
This paper describes a new pilot development of ARDUINO based health monitoring system to make a Long Range Wireless Data Acquisition System (LRW-DAQ). This device is used for monitoring the wheel load and the vibration of the slab when the rail car passed. Because the existing DAQ systems are usually expensive and complicated for setup and maintenance, they are not suitable to build an IoT system to monitor the railway slab track system. For this purpose, the prototype, which is made from Teensy-a USB-based microcontroller development system, is made to capture the data. Then the data will be stored in SD card. After that, it will be transferred to the coordinator via ZigBee/IEEE 802.15. 4 protocol. This system has been tested by comparing with another commercial DAQ system.
© Đại học Đà Nẵng
Địa chỉ: 41 Lê Duẩn Thành phố Đà Nẵng
Điện thoại: (84) 0236 3822 041 ; Email: dhdn@ac.udn.vn