Home
Giới thiệu
Tài khoản
Đăng nhập
Quên mật khẩu
Đổi mật khẩu
Đăng ký tạo tài khoản
Liệt kê
Công trình khoa học
Bài báo trong nước
Bài báo quốc tế
Sách và giáo trình
Thống kê
Công trình khoa học
Bài báo khoa học
Sách và giáo trình
Giáo sư
Phó giáo sư
Tiến sĩ
Thạc sĩ
Lĩnh vực nghiên cứu
Tìm kiếm
Cá nhân
Nội dung
Góp ý
Hiệu chỉnh lý lịch
Thông tin chung
English
Đề tài NC khoa học
Bài báo, báo cáo khoa học
Hướng dẫn Sau đại học
Sách và giáo trình
Các học phần và môn giảng dạy
Giải thưởng khoa học, Phát minh, sáng chế
Khen thưởng
Thông tin khác
Tài liệu tham khảo
Hiệu chỉnh
Số người truy cập: 106,970,030
Effect of Styrene-Butadiene Copolymer Coating on Properties of Rubberized Cement-Based Composites
Tác giả hoặc Nhóm tác giả:
Ngoc Phuong Pham, Ahmed Toumi, Anaclet Turatsinze
Nơi đăng:
RILEM Bookseries (International Conference on Strain-Hardening Cement-Based Composites);
S
ố:
10.1007/978-94-024-1194-2_40;
Từ->đến trang
: 342-350;
Năm:
2018
Lĩnh vực:
Kỹ thuật;
Loại:
Bài báo khoa học;
Thể loại:
Quốc tế
TÓM TẮT
ABSTRACT
Properties of improved strain capacity and high shrinkage cracking resistance make rubberized cement-based composites suitable for large surface applications such as pavements and thin bonded cement-based overlays. Microstructurally, the interfacial transition zone (ITZ) between rubber aggregate and cementitious matrix is different from that encountered with conventional aggregates. It is universally accepted a reduction in mechanical properties due to the low stiffness of rubber aggregates. However, transport properties are possible to be improved and comparative with conventional concrete or mortar if bonds between rubber particle and cementitious matrix were induced by pre-coating rubber aggregates to become hydrophilic and preventing air-entrapment phenomenon’s during mixing and placing composites. In this study, two distinct solutions were suggested to improve properties of composites such as using air-detraining admixture and styrene-butadiene copolymer as agent for rubber aggregate coating. Rubber particles with sizes 0–4 mm were incorporated in mortar as 30% sand replacement by volume. Microstructural analysis by Scanning Electron Microscopy (SEM) clarified the dense interface due to bonds generated by coagulation of the cement paste-polymer on the rubber surface. The initial experimental results showed a reduction in air permeability of composites modified with styrene-butadiene copolymer. As expected, this treatment method also contributed positively to mechanical properties of composites, especially direct tensile strength
© Đại học Đà Nẵng
Địa chỉ: 41 Lê Duẩn Thành phố Đà Nẵng
Điện thoại: (84) 0236 3822 041 ; Email: dhdn@ac.udn.vn