Thông tin chung
  English
  Đề tài NC khoa học
  Bài báo, báo cáo khoa học
  Hướng dẫn Sau đại học
  Sách và giáo trình
  Các học phần và môn giảng dạy
  Giải thưởng khoa học, Phát minh, sáng chế
  Khen thưởng
  Thông tin khác
  Tài liệu tham khảo
  Hiệu chỉnh
 
Số người truy cập: 107,023,773

 Behavior of a Tilting-Pad Journal Bearing With Different Load Directions
Tác giả hoặc Nhóm tác giả: Phuoc Vinh Dang, Steven Chatterton, Paolo Pennacchi, Andrea Vania, Filippo Cangioli
Nơi đăng: ASME International Design Engineering Technical Conferences and Computers and Information in Engineering Conference, Boston, Massachusetts, USA, 2015; Số: 8;Từ->đến trang: V008T13A067; doi:10.1115/DETC2015-46598;Năm: 2015
Lĩnh vực: Kỹ thuật; Loại: Báo cáo; Thể loại: Quốc tế
TÓM TẮT
abortion stories gone wrong how to abort at home teenage abortion facts
ABSTRACT
Tilting–pad journal bearings (TPJBs) are widely used in rotating machinery to support the rotors efficiently at elevated speeds under light/heavy loadings. Because of the importance of this machine component, many authors have published several theoretical and experimental studies, to evaluate the influence of clearance, lubricant temperature, oil flow-rate and thermal effects on behavior of TPJB. However, the investigations of the influence of loading direction on properties of TPJB are very limited. In bearing models as well as in experimental tests, the load is often assumed along the vertical direction only and the geometry of the bearing is the same for each pad, which corresponds to an axial symmetry of the bearing. This paper presents first a theoretical analysis of the influence of the load direction on both the static and the dynamic behavior of a five-pad TPJB with a non-uniform clearance: that is, the different bearing configurations in the range between load-on-pad (LOP) and load-between-pads (LBP) are investigated. Then, the analytical results are compared with experimental measurements. The tests were performed with a nominal diameter of 100 mm and a length–to–diameter ratio of 0.7, using a suitable test-rig, in which it is possible to apply the static load in any direction. The procedure for the estimation of the bearing geometry from experimental measurement of the non-uniform clearance profile is also described. The results show that the load direction has considerable effects on both the static and the dynamic characteristics of the TPJB. Besides, the influence of load directions is stronger on the dynamic characteristics of tilting pad bearing than on the static ones.
© Đại học Đà Nẵng
 
 
Địa chỉ: 41 Lê Duẩn Thành phố Đà Nẵng
Điện thoại: (84) 0236 3822 041 ; Email: dhdn@ac.udn.vn